What is the maximum number of power supplies possible in a VSP 9000 chassis?
After a reset patch is applied on a VSP 9000, what happens by default, if the software patch commit command is not executed?
A. The system sends an alert.
B. Auto-rollback is triggered by default.
C. Auto commit is triggered by default.
D. After thirty minutes, commit time switches to ‘hold’.
A technician is working on a VSP 9000 and trying to determine why IST in not coming up, even though it is enabled. The configuration looks good. What should he checked next?
A. the network loops
B. the slow SFPs
C. the Key Health Indicators (KHI) stats
D. the physical layer
VSP 9000 fast re-route technology extends over the IST to include all of the local and remote ports in the switch pair. How are link state message carried between the switch pair?
A. with FDR entries
B. using peer IP addresses
C. over SMLT ports
D. over the IST ports
How does the VSP 9000 avoid loops related to MAC addresses?
A. It uses source learning for SimpleLoop Prevention Protocol (SLPP) Source MAC.
B. If the chassis detectsthe SLPP packet source address is theIST MAC, it shuts down the port receiving that packet.
C. The destination MAC address is always on the secondary switch.
D. If the chassis detects itsown source MAC address in an SLPP packet, it shuts down the port receiving that packet.
A technician is troubleshooting traffic problems on a VSP 9000 and finds that Spanning Tree Protocol (SIP) is blocking the MultiLink Trunking (MLT) ports.
How can this problem be solved?
A. Bounce the ports.
B. Disable SIP then bounce the ports.
C. Disable STP then reboot the CPU.
D. Reboot the CPU then bounce the ports.
With an ACL being identified by a unique system wide ACL ID in the range of 1-2048, what does the number 2048 represent?
A. the maximum enabled ACLs for the VSP 9000
B. the maximum supported ACLs for the network
C. the maximum supported ACLs for the VSP 9000
D. the maximum supported ACLs and ACEs for the network
How can configuration redundancy be achieved on a VSP 9000?
A. Use two Compact Flash (CF) cards, one mirroring the other.
B. Define the primary and backup configuration file paths.
C. Partition the system flash memory to provide two copies.
D. Define the secondary and tertiary backups to the primary configuration file path.
In a VSP 9000 Open Shortest Path First (OSPF) configuration, how can the technician ensure the avoidance of excessive shortest path calculations?
A. Use the same number of OSPF areas for each switch.
B. Minimizethe number of OSPF areas for each switch.
C. Use the default number ofOSPF areas for each switch.
D. Set the switch to manage the number of OSPF areas it uses.
How does a technician access Flight Recorder functionality?
A. User-mode CLI
C. menu item selection
D. through the traffic surveillance utility
…go to http://www.lead2pass.com/3601.html to download the full version Q&As.