Section 4 – Cisco Unified Communications Manager
In which two locations can an end user configure their Call Forward All settings? (Choose two.)
A. Cisco Unified Serviceability
B. Cisco Unified Communications Manager User Options Interface
C. Directly on the Cisco Unified IP phone
D. Cisco Unified Communications Manager Administration
E. Cisco Unified User Serviceability
What is the quickest way to test the Cisco Unified Communications Manager configuration part of MWI to see if MWI On and MWI Off is working?
A. Dial into Cisco Unity Connection from an IP phone. Enter the MWI On numbers,then enter the
MWI Off numbers.
B. Call a voice-mail user and ask them if their MWI light is on, and then disconnect the call. Call the
user back and ask if the MWI light is off.
C. In Unity Connection, issue the MWI Flash command to turn all MWI lights on, then off.
D. If MWI numbers aredialable from an IP phone, dial the MWI On number. If the light comes on,
then dial the MWI Off number to see if the light goes off.
E. MWI cannot be tested directly from the Cisco Unified Communications Manager or an IP phone.
To obtain CDR information, which application is used?
A. Cisco Unified Communications Manager Administration
B. Cisco Unified Serviceability
C. Cisco Unified Operating System Administration
D. Disaster Recovery System
E. Cisco Unified Communications Manager Call Detail Record Analysis and Reporting tool
F. Cisco Unified Reporting
What component does Cisco Unified Communications Manager Express use to match outbound dial peers?
A. destination pattern
B. incoming called-number
C. calling number ANI
E. port or session target
In Cisco Unified Communications Manager Native Presence, what two things is a watcher monitoring in real time? (Choose two.)
A. registration status of a specific IP phone
B. registration status of the hunt group
C. registration status of the MGCP gateway
D. registration status of Cisco Extension Mobility of the IP phone
E. status of a registered directory number